Fertiliser jobs

1. Choose New Fert Job from the main screen.
2. Enter the customer, aircraft and task, then add the total amount of fertiliser.
3. Select the fertiliser type and application rate. Check the aircraft and job values before calculating loads.

Tap CALCULATE LOADS once the aircraft, fertiliser rate and total amount are entered. Review the number of loads, area per load and total coverage. The job uses these values when automatic load calculations are enabled.

Check the components before starting the job. Swipe a component to reveal its available actions: delete an item you do not need, or edit a value where the app allows it.

Automatic load calculations are enabled by default. To enter coverage yourself, turn off USE CALCULATE LOADS and enter the area covered for each load.

1. Enter any known ferry time.
2. When ready to begin a load, tap Add Load, then Start.
3. Tap Stop on return and repeat for each load until the job is finished.

Tap Complete Job when the operation is finished. Check the recorded loads, coverage and time in the job summary before saving or sending the report.

With an active subscription, you can save the completed report for later or email it from the report screen. Set a default recipient in Settings → Email Settings if you regularly send reports to the same person.